Pulsar Thermal Zeroing Targets
Pulsar Thermal Zeroing Targets
The Pulsar thermal targets provide a clear point for zeroing using a thermal imaging scope. Unlike passive thermal targets, these do not require ambient light to activate and allow you to place them anywhere. Each pack contains ten 30x30cm targets with grids and ten 40mm heat pads.
Stock Alert
Please alert me via email when this product is back in stock.
Pulsar Thermal Zeroing Targets are the perfect solution for simple and precise zeroing of thermal imaging riflescopes.
Pack contains ten 30x30cm paper targets and ten 40mm carbon activated adhesive heating pads.
The adhesive heating pads will remain hot for 10-20 minutes on cold surfaces depending on weather conditions.
Further Information
Instructions for use:
- The heat pack is air-activated, do not open the pad packaging until you are ready to use it.
- Open the packaging and take out the heat pad.
- Remove the paper strip from the back side of the heat pad to expose the adhesive surface.
- Stick the heat pad with the adhesive side to the centre of the paper target marked with circle.
- Attach the paper target to the desired location.
- Aim at the heated pad through your thermal imaging scope and focus, so that the thermal pad is clearly visible.
- Zero as normal, the round shape and small diameter of the pad means that deviations of point of impact can be eliminated in just a few shots.
Delivery and Returns
Delivery
Returns
Pulsar Thermal Zeroing Targets are the perfect solution for simple and precise zeroing of thermal imaging riflescopes.
Pack contains ten 30x30cm paper targets and ten 40mm carbon activated adhesive heating pads.
The adhesive heating pads will remain hot for 10-20 minutes on cold surfaces depending on weather conditions.
Instructions for use:
- The heat pack is air-activated, do not open the pad packaging until you are ready to use it.
- Open the packaging and take out the heat pad.
- Remove the paper strip from the back side of the heat pad to expose the adhesive surface.
- Stick the heat pad with the adhesive side to the centre of the paper target marked with circle.
- Attach the paper target to the desired location.
- Aim at the heated pad through your thermal imaging scope and focus, so that the thermal pad is clearly visible.
- Zero as normal, the round shape and small diameter of the pad means that deviations of point of impact can be eliminated in just a few shots.
Delivery
Returns